The Hardest Coating Isn't Always the Right Coating
There's a ladder in the trade, and it's worth knowing. At the bottom sits a waterborne alkyd. Above it, a urethane trim enamel. Above that, a 1K polyurethane. And at the top, a 2K polyurethane — the hardest of the lot, and the most chemically resistant.
But that ladder ranks hardness, not suitability. And suitability is what decides whether a finish works in your kitchen.
The top rung gets its hardness from a hardener. A 2K finish is two parts mixed together: a resin and an isocyanate hardener that crosslink into a rigid film. That chemistry needs a spray booth, because a 2K has to be sprayed — rolled, it orange-peels — and it needs the booth to contain what spraying puts in the air. And containing it means filtering the exhaust. Without a filter, the overspray isn't captured — it's just dispersed, blown outside into the air around the house. Sprayed particles also carry a charge, so without airflow pulling them toward a filter, they drift and cling to whatever they land on instead of reaching it. With a 2K, that overspray carries isocyanate with it.
Isocyanates irritate airways, can bring on asthma hours later, and once a person is sensitized, even a minimal amount can set it off again (Ontario's guidance on isocyanates, O. Reg. 490/09:) https://www.ontario.ca/page/isocyanates-auto-body-shops). Your home is not an auto body shop; however, isocyanates do not know the difference. Spray It Like New® does NOT spray 2K with isocyanates. When we do spray inside a home, or where a customer has breathing sensitivities, such as asthma or allergies, we run a commercial air scrubber with three-stage filtration, carbon at the end for VOCs, and a negative air stage. The air is filtered, not just moved. So the top rung comes with a booth in your home, a kitchen masked off and closed from use for up to five days, and a finish that has to be sprayed in the place where you cook. We have customers who specifically request no spraying in their home.
That's why the top rung stays in the shop.
The Spray It Like New® system sits a rung down on paper, then closes the gap with the parts the ladder doesn't measure.
It starts with the primer, and the primer is worked in by hand. Zinsser B-I-N shellac primer goes on with a 5mm, 4-inch roller — on any porous material, not just oak — because a roller pushes the primer into the grain and fills the pores where a spray gun would only lay a film over them. Plain and simple, it bites better. Left dry overnight, it sands smooth like glass, so the colour coat flows and takes the shape of the surface below it.
The doors go to the shop and are sprayed lying flat in the booth — never hanging. The colour coat is Gemini EVO Eclipse, a 1K urethane crosslinker. The boxes stay in the home and are finished by hand, mostly — no spray booth set up in your kitchen unless you specifically ask for it, it comes with additional set up charges — and they air-cure there. The boxes get no clear coat and no infrared cure; those are for the doors.
Why no clear on the boxes? Because the clear goes where the wear is — no extra cost, just extra protection. Doors and drawer fronts are touched, grabbed, and cleaned every day; frames stand still. The boxes already carry the primer and the colour coat — the clear is the extra layer of armour. And the clear's full value comes with the shop: sprayed flat and infrared-cured before it comes home. On a box it would air-cure, take longer to harden, and risk dust in the finish while it sits, for very little gain.
Then the clear. One coat of Varathane Nano Defense clear on the doors — a finish made for floors, the hardest-working surface in the house. The colour coat gets its colour from pigment; the clear coat on the doors gets its toughness from aluminum oxide — tiny, extremely hard particles in the film that take the wear instead of the colour. Its own data sheet measures it: 4H pencil hardness, about 34 mg lost in the Taber abrasion test, and top KCMA marks on coffee, mustard, and water. That's a different route to hardness than a 2K, which gets there by crosslinking its resin with an isocyanate hardener. One is armour in the film; the other is chemistry in the resin.
Two coats, two jobs: the colour coat brings the colour with flexibility, the clear coat on the doors brings the hardness and extra scratch, chemical & water resistance over and above the colour coat.
Crosslinking is a trade word, and it's worth saying plainly. As the finish dries, it locks itself together into one connected skin instead of a layer of dried paint — so it doesn't soften back up under cleaner or water, and it holds instead of easily chipping. The 1K colour coat crosslinks as it dries; that's built into the coating itself. The 2K route gets there by adding the hardener. Same word, different route — and only the hardener route puts isocyanates in the air.
And the combination itself is honest about where it comes from. Varathane's own sheet covers applying Nano Defense over a thoroughly dry paint, with a test spot first. One coat over EVO is our own tested combination on top of that — worked out over 18 years and 945 kitchens, not bought off a shelf.
Then the cure. The colour coat and the clear on the doors each get a 20-minute infrared cure — the InfraKure® step — before the doors leave the shop. The finish is cured, not just dry to the touch, when it comes home. Nobody else in this market advertises infrared curing. And the manufacturers back the step: Gemini's own sheet for EVO says infrared lighting for cure will significantly decrease dry times, and Envirolak recommends an infrared cure for its topcoat. It's in their material sheets — we're the ones advertising it.
The system is backed by our NEW 5-Year No Peel Warranty.
And it all happens with no spray booth in your kitchen, no isocyanate anywhere in the system, and no closing your kitchen off from use for up to five days.
Get a free quote from us. Call or text us at (519) 401-3161.
See the process, the pricing, and the warranty.https://www.sprayitlikenew.kitchen/kitchen-cabinet-painting-processhttps://www.sprayitlikenew.kitchen/kitchen-cabinet-painting-pricinghttps://www.sprayitlikenew.kitchen/kitchen-cabinet-painting-warranty






Comments